1. Start: Input Material & Thickness

• Node: Start

2. Determine Base Amplitude (Material Structure)

1. Decision: Is Material Semi-Crystalline (e.g., PP, PA)?

• Yes: → Process: Set Base Amplitude to HIGH (50-70 μm).

• No (It is Amorphous): → Process: Set Base Amplitude to LOW (30-45 μm).

3. Adjust for Thickness (Far Field & Thinness Check)

1. Decision: Is Thickness > 6 mm (Far Field)?

• Yes: → Process: Increase Amplitude +20% (Compensate Damping Loss).

• No: → Go to next check.

2. Decision: Is Thickness < 1 mm (Thin/Delicate)?

• Yes: → Process: Decrease Amplitude -15% (Avoid marking/cracking).

• No: → Finalize Amplitude.

4. Output Final Amplitude

• Node: Output Final Amplitude (μm)